SOYO SY-6BE+ User Manual

Page 9

Advertising

SY-6BE+ Quick Start Guide

Hardware Installation

Step 6.

Clear CMOS Data (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5
seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily
identified by its white colored cap.

CMOS Clearing

Clear CMOS Data

Retain CMOS Data

JP5 Setting

Short pin 2-3 for
at least 5 seconds
to clear the CMOS.

Short pin 1-2
to retain the
new settings.

Note: You must unplug the ATX power cable from the ATX power connector when
performing the CMOS Clear operation.

Note on Over-clocking Capability

The SY-6BE+ provides over-clocking capability. Due to the over-clocking setting your system
may fail to boot up or hang during run time. Please perform the following steps to recover
your system from the abnormal situation :
1. Turn off system power. (If you use a ATX power supply, sometimes you have to press the

power button for more then 4 seconds to shut down the system)

2. Press and hold down the <Insert> key while turning on the system power. Keep holding

down the <Insert> key until you see the message of the CPU type and frequency shown
on the screen.

3. Press the <Del> key during the system diagnostic checks to enter the Award BIOS Setup

program.

4. Select [SOYO COMBO SETUP] and move the cursor to the [CPU Frequency] field to set

the proper working frequency.

5. Select [Save & Exit SETUP] and press <Enter> to save the new configuration to the

CMOS memory, and continue the boot sequence.

Note: SOYO does not guarantee system stability if the user over clocks the system.

Any malfunctions due to over-clocking are not covered by the warranty.

Advertising