Siemens Simotion A4027118-A0414 - Manual (Page 51)

Section B: The application example as demonstration
system
O t t l f th li ti l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 51/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
5.2.3 Machine parameter settings
The standard application allows the following parameters to be adapted:
Machine geometry
• Distance to sensor
Distance between the flying saw axis and the sensor of the material and
print mark detection
• StartPosition
Position from which the flying saw starts motion to achieve synchronism
(with the material web)
• StartSyncPosition
Position at which the flying saw is synchronized, start of the
synchronous traversing range
• EndSyncPosition
End of the synchronous traversing range
• EndPosition
Maximum traversing range of the flying saw
Flying Saw Axis Accelerations
• Cut
Acceleration value for synchronization
• Back
Acceleration value for return motion
• Gap
Acceleration value for creating a "gap".
Creating a "gap"
• GapVelocity
Additional velocity in order to create a gap between the material and the
cut piece