Siemens Simotion A4027118-A0414 - Manual (Page 78)

Section C: Integrating the core “flying saw” functions
Integrating the core “flying saw” functions
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 78/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
7.5 Assigning the synchronous relationships
7.5.1 FlyingSawAxis_SYNCHRONOUS_OPERATION
Configuration
• Select
the MaterialAxis as master (leading) axis
• Select
setpoint coupling as coupling type.
Pre-assignment (gear synchronization)
• Synchronizing:
Enter the synchronizing position of the master (leading) axis and
slave (following) axis
(this is checked and corrected by the FlyingSaw FB)
• Position reference:
Synchronize before the synchronizing position
(this is checked and corrected by the FlyingSaw FB)
• SyncPos master (leading) value:
0.0
(the FlyingSaw FB enters the actual value)
• SyncPos slave (following) axis:
0.0
(the FlyingSaw FB enters the actual value)
• The other values are no longer relevant.
Pre-assignment (dynamic)
• Profile
input: Time-related synchronizing profile
(this is checked and corrected by the FlyingSaw FB)
• Please select the dynamic parameters of the time-related
synchronization so that the FlyingSawAxis does not reach the dynamic
limits when synchronizing and de-synchronizing.