Sony PSP Go PSP-N1001 - Manual (Page 46)


Before requesting service
Bluetooth
®
The Bluetooth
®
device cannot be registered, or paired, with
the PSP
®
system.
 There may be too much distance between the system and
the Bluetooth
®
device.
 The Bluetooth
®
device may not be compatible with the
profiles that are supported by the system.
 The maximum number of Bluetooth
®
devices that can be
paired is eight. Try deleting a registered device to pair a
new device.
A connection cannot be established between the Bluetooth
®
device and the PSP
®
system.
 Check that the Bluetooth
®
device is paired with the system.
If it is not paired, go to (Bluetooth
®
Device Settings)
[Manage Bluetooth
®
Devices] [Register New Device] to
pair the device.
 Check that the Bluetooth
®
device is turned on.
 If the Bluetooth
®
device has been reset, you must pair it
with the system again.
There is no sound from the Bluetooth
®
device.
 Check that the Bluetooth
®
device is not set in mute mode.
 Try adjusting the volume on either the Bluetooth
®
device or
the PSP
®
system.
There is noise. The sound is not continuous.
 If there are obstacles such as walls between the PSP
®
system and the Bluetooth
®
device, change the location of
the devices and then connect the Bluetooth
®
device again.
 If a device that causes radio interference such as a
microwave oven or an induction cook top or appliance is
nearby, communication with the system may not work
properly.
There is a delay in the audio.
 Due to the characteristics of Bluetooth
®
technology, there
may be a delay in the audio. If you feel the lag in the audio
is a problem, use wired headphones instead.
Other issues
The system or AC adaptor is warm.
 During use, the system or AC adaptor may become warm.
This is not a malfunction.
 When the communication function is being used, the
system may become warmer than during normal use. This
is not a malfunction.
The system is turned on, but does not operate.
 Check that the system is not in hold mode. If it is, slide the
POWER/HOLD switch up to clear hold mode.