Sharp TL-M4600 - Manual (Page 23)


Preparation
Connecting the Power Cord
Caution
• Do not use a power cord other than the one
supplied with the monitor.
Be sure to use a power outlet of
AC 120 V (60 Hz).
Using power supply other than the
one specified may cause fire.
• Place the monitor close to the AC outlet, and
keep the power plug within reach.
• This product must only be connected to an AC
0 V, 60 Hz, grounded (3-prong) outlet.
Connecting it to any other kind of outlet will
damage the product and invalidate the warranty.
1 Plug the power cord (supplied) into the AC input
terminal.
2 Plug the power cord (supplied) into the AC power
outlet.
Binding Cables
Hole
for
the
power
cord
clamp
Fastened
part
Band
Power
cord
clamp
1 2 3
n Attaching the cable clamp
The cables connected to the terminals on the back
of the monitor can be neatly bundled using the
supplied cable clamp as shown in the illustration.
• A cable clamp cannot be easily removed once it is
attached.
Note
n Fastening the power cord
The power cord can be fastened using the supplied
power cord clamp. This will prevent the power cord
from being disconnected accidentally.
1 Attach the supplied power cord clamp to the
power cord, making sure the power cord clamp is
circular hole-side down.
2 Insert the tip of the band into the hole for the
power cord clamp.
3 While holding the tail of the band, slide the
fastened part toward the AC input terminal.