Samsung 26-446 - Manual (Page 3)

3
For maximum comfort, keep your elbows
close to your sides and rest your forearms
on your lap if you play for a long time.
Notes:
• You cannot use the thumb-control pad
when the gamepad is set to analog
mode. You cannot use the joystick when
the gamepad is set to digital mode.
• In either mode, you can use either
thumb to set the A , B , R1/R2 , C , D , T1/
T2 , ANALOG/DIGITAL , or THROTTLE/T1/
T2 switches.
Using the Joystick
The joystick works when the gamepad is set to
analog mode (see Step 5 under “Using the
Gamepad” on Page 2).
Using the Analog Throttle
The analog throttle (marked THROTTLE ) works
when the gamepad is set to analog or digital
mode (see “Using the Gamepad” on Page 2).
To use the analog throttle, set
THROTTLE/T1/
T2 to THROTTLE . This disables the T1 and T2
buttons. Then slide the THROTTLE switch to
the desired level. To disable the analog throt-
tle, set
THROTTLE/T1/T2 to T1/T2 . This acti-
vates the T1 and T2 buttons.
Note: The analog throttle works only with
games that support analog mode.
CONFIGURING THE
GAMEPAD IN WINDOWS 95/98
(WITHOUT THE SUPPLIED
DRIVER)
1. Set the R1/R2 and T1/T2 switches to NOR-
MAL .
2. If you want to use the gamepad’s throttle,
set the THROTTLE/T1/T2 switch to THROT-
TLE .
3. From the Start Menu, select Settings,
then click on Control Panel.
4. Double-click the Game Controllers icon.
5. Remove any previously selected control-
ler drivers.
6. Click on Add.
7. Select Custom under Joystick Selec-
tion.
8. Enter a name for the controller, select 4
Axes and 4 Buttons, then click OK.
9. Select the mode you want to use (Analog
or Digital), then click on Properties.
10. Highlight the name of the controller you
entered in Step 8, then click on Proper-
ties.
11. Click on Calibrate then press the control-
ler’s buttons to calibrate it.
12. If your game uses a throttle control, cali-
brate it by alternately pressing T1 and T2
several times (if you set THROTTLE/T1/T2
to T1/T2 ), or slide THROTTLE back and
forth several times (if you set THROTTLE/
T1/T2 to THROTTLE ). If your game uses a
rudder control, calibrate it by alternately
pressing
R1 and R2 several times.
13. When you have finished calibrating the
gamepad, click FINISH then click TEST .
Press the gamepad’s buttons to test it.
Note: During the test, the throttle and rud-
der indicators should appear in the center
of the two vertical bars. These indicators
move up when you press
T1 or R1 and
move down when you press T2 or R2 . Do
not press T1 and T2 or R1 and R2 at the
same time.
CALIBRATING THE GAMEPAD
USING THE SUPPLIED
DRIVER
Important:
• If you install a game card that works at a
different speed after you calibrate your
gamepad, you must re-calibrate the
gamepad.
• The supplied driver works only with 1-
player 8-button configuration.
Note: Make sure the gamepad is set to the
mode you want (digital or analog) before you
calibrate it. See Step 5 under “Using the
Gamepad” on Page 2.
26-446.fm Page 3 Friday, July 9, 1999 9:45 AM