Sony MDS-JE780 - Manual (Page 7)

G
e
tting
Star
ted
7
GB
Required cords
A Audio connecting cords (2) (supplied)
When connecting an audio connecting cord, be sure to
match the colour-coded pins to the appropriate jacks:
white (left) to white and red (right) to red.
B Optical cables (2 for European model/3
for other model) (only one supplied)
• When connecting an optical cable, insert the cable
plugs straight in until they click into place.
• Do not bend or tie the optical cables.
C Coaxial digital connecting cable (for
European model only) (1) (not
supplied)
Hookup considerations
• Turn off the power of all components before
making any connections.
• Do not connect any mains lead until all the
connections are completed.
• Be sure the connections are firm to prevent hum
and noise.
Jacks (connectors) for
connecting audio
components
For European model
For other model
Setting the voltage selector
(only on the model supplied
with a voltage selector)
Check that the voltage selector on the rear panel
of the deck is set to the local power line voltage.
If not, set the selector to the correct position
using a screwdriver before connecting the mains
lead to mains.
White (L) White (L)
Red (R) Red (R)
Connect To the
Amplifiers ANALOG IN/OUT jacks
CD players or DBS
tuners DIGITAL COAXIAL IN
jack or DIGITAL
OPTICAL IN connector
Digital amplifiers, DAT
decks, or another MD
deck DIGITAL OPTICAL IN/
OUT connectors
Connect To the
Amplifiers ANALOG IN/OUT jacks
CD players or DBS
tuners DIGITAL OPTICAL IN 1)
connector
1) There is no distinction of IN1 and IN2
connectors.
Digital amplifiers, DAT
decks, or another MD
deck DIGITAL OPTICAL IN 1) /
OUT connectors
continued