Sanyo CCA-BC200 - Manual (Page 24)

23
REAR VIEW BACK UP CAMERA DISPLAY
AND SWITCHING DISPLAY MODES
Preparation prior to use
Make sure the ignition switch is in the ON or ACC position.
1.
Turn the monitor on and select the input mode
switch to view the image from the rear view camera
on the screen. (Refer to the instruction manual for
the monitor for details.)
2. Set the selector shift lever to R (reverse).
A digitally corrected rear view will be visible on the
screen.
3.
Press the control switch to change the display mode.
• The rear view back up camera system is a devise designed only to assist the
driver. The driver remains responsible for being aware of and confirming the
vehicle surroundings. For safety reasons, it is important for the driver to take
extra precautions when backing up.
CAUTION
Need help? Call
1-800-421-5013
• After the ignition switch is turned from off to the ACC ON or ON position, a digitally
corrected rear view is displayed on the screen first.
• When changing the display mode, the selected display mode remains until the
ignition switch is turned off.
• The rear view of the vehicle is not displayed while the vehicle is not in reverse.
Notes
Digitally corrected rear view View-from-top Standard view
• If the image turns off automatically after the guide line alignment, turn the ignition
switch off, then to the ACC ON or ON position prior to the following procedure.
CAUTION