Sony IT-M804 - Manual (Page 20)

Getting Started 20 US
4
Press Jog Button again.
5
Enter three digits of your home area code by
pressing the dialing keys.
6
Press Jog Button.
You will hear a long confirmation beep.
Notes
• Do not allow more than 20 seconds to elapse between each step of the procedure.
• If the home area code has not been entered, storing the caller ID data into one-touch dial
buttons or Phone Directory cannot be performed. You will hear five short error beeps and the
storing will be canceled.
Tip
You can press (PROGRAM) instead of Jog Button in the procedure above.
To change the home area code
1
Display the home area code by doing steps from 1 to 4 on pages 19 to 20.
The current home area code appears on the display.
2
Enter a new home area code by pressing the dialing keys.
3
Press Jog Button.
You will hear a long confirmation beep.
Tip
You can also correct a digit in step 2. Turn Jog Dial until the digit to be corrected flashes and
enter a digit by pressing the dialing keys.
To enter the local area code (For 10 digits phone
numbers users)
If a call matches one of the local area codes you entered, the phone number will be
registered with 10 digits in the Caller ID list (area code + number). If a call does not
match one of the local area codes you entered, the phone number will be registered
with 11 digits in the Caller ID list (1 + area code + number). Some regions of the
country allow you to have more than one local area code. (Up to five local area codes
can be entered in this phone.)
1
Press (PROGRAM).
2
Turn Jog Dial up until “AREA
CODE” appears on the display.
3
Press Jog Button.
(ERASE/CLEAR)
AREA CODE=???
Step 3: Entering the area code (continued)