Sony DAV-HDX500 - Manual (Page 85)

Ad
v
a
nce
d
Se
ttings
an
d Adju
stme
nts
masterpage:Right
specdef v20061206
filename[E:\SS2007\Models\DC5\2895962131\2895962131DAVHDX500-501W\gb11adv.fm]
model name [DAV-HDX500/HDX501W]
[2-895-962-13(1)]
85 US
Connect the calibration mic to the A.CAL
MIC jack on the front panel, and set it up at
the ear level using a tripod, etc. (not
supplied). The front of each speaker should
face the calibration mic, and there should be
no obstruction between the speakers and the
calibration mic. Be quiet during the
measurement.
5
Press X/x to select [YES], then press
.
Calibration starts.
Note
• Avoid being in the measurement area and
making noise during the measurement (about
one minute), to avoid measurement failure.
During the measurement, test signals are output
from the speakers.
• The environment of the room in which the
system is installed may affect measurements.
• If an error message appears, follow the message,
then select [YES].
An error message appears when:
– the headphones are connected.
– the calibration mic is not connected.
– front speakers are not correctly connected.
– surround speakers are not correctly
connected.
– front and surround speakers are not correctly
connected.
– subwoofer is not connected.
6
Press C/X/x/c to select [YES] or [NO],
then press .
x The measurement is OK.
Disconnect the calibration mic, then select
[YES]. The result is implemented.
x The measurement is not OK.
Follow the message, then select [YES] to
retry.
Tip
• You can check the distance between the listening
position and each speaker. See page 92.
AUDIO IN / A.CAL MIC
Calibration mic
Measuring. Please wait a moment.
FRONT L :
FRONT R :
CENTER :
SUBWOOFER :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
“YES”.
YES
16ft 4.87m 0.0dB
16ft 4.87m 0.0dB
16ft 4.87m + 1.0dB
16ft 4.87m + 4.0dB
10ft 3.04m - 2.0dB
10ft 3.04m - 2.0dB
Measurement complete.
NO
Check speaker connection.
Retry?
YES
Measurement failure.
NO
continued