Sony DVP-K333 - Manual (Page 12)

12
Getting Started
5.1 Channel Surround Hookups
With DVDs which contain DTS, Dolby* Digital or MPEG
AUDIO sound, you can enjoy the surround sound while
producing the effect of being in a movie theater or a
concert hall, using a digital component with a built-in
DTS, Dolby Digital or MPEG decoder (not supplied). The
player outputs the surround sound signals from the
DIGITAL OUT OPTICAL and COAXIAL connectors.
Note
When a DVD has a sound track with 7.1 channels recorded in
MPEG AUDIO format, the output audio signals are mixed down
to 5.1 channels.
Required cords
Audio cords (not supplied)
One for the LINE OUT AUDIO jacks
Optical or coaxial digital cord (not supplied)
One for the DIGITAL OUT jacks
or
S video cord (supplied)
One for the S VIDEO OUT jacks
Connect the component via the DIGITAL OUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied). You do not need to connect both
of these cords. See the figure on the next page.
Notes
• Do not connect the power cord to an AC outlet or press the
POWER switch before completing all connections.
• Refer to the instructions supplied with the component to be
connected.
• The cord connectors should be fully inserted into the jacks.
Loose connection may cause hum and noise.
• Jacks and plugs of the connecting cords are color-coded as
follows:
Red jacks and plugs: Right audio channel
White jacks and plugs: Left audio channel
Setups for the player
Some setups are necessary for the player depending on
the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 46.
• When you play a DVD or CD that are recorded in
DTS format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and
then set “DTS” to “ON” in the setup display. (page 56)
• When you play a DVD that is recorded in Dolby
Digital format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and
then set “DOLBY DIGITAL” to “DOLBY DIGITAL” in
the setup display. (page 55)
• When you play a DVD that is recorded in MPEG
format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and
then set “MPEG” to “MPEG” in the setup display. (page
56)
Notes
• Refer to the instructions supplied with the component to be
connected.
• When you do not connect an audio component with a built
in DTS decoder, do not set “DTS” to “ON.”
• When you do not connect an audio component with a built
in DOLBY DIGITAL decoder, do not set “DOLBY DIGITAL” to
“DOLBY DIGITAL.”
• When you do not connect an audio component with a built
in MPEG decoder, do not set “MPEG” to “MPEG.”
White (L)
Red (R) Red (R)
White (L)
* Manufactured under license from Dolby Laboratories.
“Dolby”, “AC-3”, “Pro Logic” and the double-D symbol a are
trademarks of Dolby Laboratories.
Confidential Unpublished Works. ©1992-1997 Dolby
Laboratories, Inc. All rights reserved.