Sony 4-170-060-12(1) - Manual (Page 31)

31 GB
A
d
v
a
n
ced
Settin
g
s
Changing the display setting
(DISPLAY)
You can change the display behavior of the front
panel display.
1
Select “SYSTEM” in the AMP menu,
then press
or c.
2
Select “ DISPLAY,” then press or c.
3
Select the setting.
• ON: The display stays turned on.
• OFF: The display appears for a few
seconds when you operate the stand.
• The display shows the kinds of input signal (digital
input only) when you press DISPLAY, even if you set
“DISPLAY” to “OFF.”
• The display stays turned on when the muting or
protection function is working, even if you set
“DISPLAY” to “OFF.”
Using the sleep timer (SLEEP)
You can set the stand to turn off at a preset time
when you want to fall asleep listening to music.
You can preset the time in 10-minute increments.
1
Select “SYSTEM” in the AMP menu,
then press
or c.
2
Select “SLEEP,” then press or c.
3
Select the preset time you want.
The minutes display (remaining time)
changes as follows:
• This function is only for this stand, not for the
connected TV or other components.
Auto Standby function (AUTO
STBY)
You can reduce power consumption. The stand
enters standby mode automatically when you do
not operate the stand for about 30 minutes and
the stand is not receiving an input signal.
The default setting is “ON”.
1
Select “SYSTEM” in the AMP menu,
then press
or c.
2
Select “AUTO STBY,” then press or
c.
3
Select the setting.
• ON: Turns on the “AUTO STBY”
function.
• OFF: Turns off the function.
• When the stand is turned off via the AUTO STBY
function, the stand may not be turned on automatically
when you turn on the TV next time.
Tip
Note
Note
OFF y 10M y 20M
Y Y
90M y 80M ... 30M
Note