SoleusAir SG-WAC-15ESE - Manual (Page 9)

ASSEMBLY & INSTALLATION (CONT.)
8
4. Install top angle side to cabinet as shown in FIG. 7.
5. Slide "I" section of window filler panel into side retainer.
Do both sides.
WINDOW FILLER PANEL
WINDOW FILLER
PANEL
SIDE RETAINER
SIDE RETAINER FIG. 8a
FIG. 7
Foam Gasket and Top
Angle Rail
Top Angle Rail and Side Bracket Installation
1. Place the air conditioner on a hard flat surface.
2. Locate the foam gasket and top angle rail
3. Attach the foam gasket to the top angle rail.
7. Install side retainer to cabinet as shown in
FIG.8b-9.
(see FIG 8b-9)
6. Insert top and bottom legs of window filler panel frame
into channel in the top angle and bottom rail. Do both
sides
FIG. 8b
PLASTIC
FRAME
WINDOW FILLER
PANEL
SIDE RETAINER
8. Once the window panels are correctly installed, for 25K
insert the washer head locking screws on the top rail and
frame. Do not tighten all the way at this time. Allow the
bottom frame to slide freely.
Placing the Cabinet Inside the Window
1. Open the window and place the cabinet in the middle
of the window sill.
2. Make sure the bottom rail is seated over the window
sill as shown below. Bring the window down temporar-
ily behind the top angle rail to hold the cabinet in place.
3. Fasten cabinet to window sill using two 7/8” Round-
head screws (3/4” ROUND-Head screws on SG-WAC-
25ESE). Pre-drill holes if needed. Add the bottom rail
seal over the screws.
FIG. 9
TOP VIEW
SILL
BOTTOM
RAIL
ROUND-HEAD SCREW
3/4"for 25ESE
7/8"for 15/18ESE