Connecting the hx810, English – Samson HyDrive HX410 User Manual
Page 9
5
ENGLISH
The HX810 impedance is 4 Ohms. So, when two HX810’s are connected together in
parallel, the total impedance is 2 Ohms. The impedance of your speaker has an effect
on your amplifier. In general, the lower the impedance, the more power your ampli-
fier will put out.
IMPORTANT: There is a minimum
safe impedance so be sure to check
the manufacturer’s recommended
impedance for your amplifier to avoid
any damage to your amplifier or void-
ing your warranty.
Connecting the HX810 to Your
Amplifier
The HX810 connections are made
via a 1/4” phone jack or Speakon
connector located on the rear panel
jack-plate. Be sure to make your con-
nection with un-shielded speaker
cable. Connect the Amplifier Output
to the speaker Input on the HX810’s
rear jackplate.
Hartke Systems
Distributed Exclusively by
Samson Technologies Corp.
Hicksville, New York 11802
MODEL 2000
200 WATTS
8
= 120 WATTS
4
= 200 WATTS
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICE-
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.
ASSEMBLED IN R.O.K.
SERIAL NUMBER
115
~ AC INPUT
115V/230V 50/60Hz
FUSE
5A/250V, 180W (115V)
2.5A/250V, 450W (230V)
SPEAKER OUTPUTS
8
8
ON
OFF
HPF
EFFECT
SEND
RETUIRN
Connecting the HX810