Sony DHG-M55CV - Manual (Page 16)

Introducing the Digital Network Receiver
10
Programming the
Wireless Keyboard The keyboard is preset at the factory to operate any Sony brand TV. If
you have any other brand of TV, use the following procedures to
program the keyboard to use any of the highlighted buttons shown
on page 8.
To program the keyboard
1 Set the keyboard’s TV/CABLE switch to TV.
2 Turn to “Wireless Keyboard Programmable Codes” on page 13,
and find the 3-digit code for your TV. If more than one code is
listed, use the number listed first to complete the following
procedures.
3 Press the CODE SET button.
4 Enter the 3-digit code for your TV using the 0-9 keys.
5 Press the OK/Enter key.
To check if the code works
1 Aim the keyboard at the TV and press TV POWER .
2 If the TV responds, try the VOLUME and MUTE buttons. If the TV
responds, you’re done.
If the TV does NOT respond
❑
Try programming the keyboard using the other codes listed for
your TV brand.
❑ If you still cannot get your TV to respond after trying all the
codes, your TV may not be compatible with this keyboard. If this
happens, you must use your TV’s remote to operate it.
Positioning the
Keyboard The keyboard functions like a remote control. To use it, just point it at
the front panel of the Digital Network Receiver. For best results, the
keyboard should be used within 30 feet of the Digital Network
Receiver, at no more than a 45° angle.
Adjusting the
Keyboard Legs To raise the legs on the keyboard, use your finger to pry up the
adjustable legs on the bottom of the keyboard until you feel them lock
into place. To lower the keyboard, push each leg down until it snaps
into the closed position.
CV.book Page 10 Thursday, November 30, 2000 2:13 PM