Sub-Zero PRO VENTILATION HOODS - Manual (Page 12)

12
H A L O G E N L I G H T I N G
All Wolf Pro ventilation hoods and hood liners
have halogen lighting with two settings.
Halogen bulbs are included with the hood.
Pro wall hoods, 30" (762), 36" (914) and 42"
(1067) wide require two 50W, 120V par 20
halogen bulbs. 48" (1219), 54" (1372), 60"
(1524) and 66" (1676) wide hoods require
three 50W, 120V par 20 halogen bulbs.
Pro island hoods, 36" (914) and 42" (1067)
wide require two 50W, 120V par 20 halogen
bulbs. 54" (1372) and 66" (1676) wide hoods
require three 50W, 120V par 20 halogen
bulbs.
Pro hood liners, 28" (711), 34" (864), 40"
(1016) and 46" (1168) wide require two 50W,
120V par 20 halogen bulbs. 52" (1321) and
58" (1473) wide hood liners require three
50W, 120V par 20 halogen bulbs.
To replace halogen bulbs, turn off the ventila-
tion hood blower and lights. Once the halogen
bulb is cool, use a soft cloth to unscrew the
bulb and replace.
W O L F P R O V E N T I L AT I O N H O O D U S E & C A R E
C L E A N I N G A N D C A R E
Most surfaces of your Wolf Pro hood are
stainless steel. Although resistant to most
stains, it is not totally impervious to damage.
G E N E R A L C L E A N I N G
Salt and some cooking liquids may pit and
stain the surface. Always remove any film
or spills immediately.
Avoid using abrasive cleaners. They will
permanently scratch the surface.
Do not use steel wool pads.
Be careful not to soak the rotary switches.
Although they are sealed, excessive
moisture may cause damage to the
controls.
Use a clean cloth or sponge, wipe with
warm water and mild detergent. Rinse and
dry immediately. Apply protective polish,
always in the same direction as the grain.
A spray degreaser will remove fingerprints
and greasy spatters. Spray on a cloth and
wipe surface. Buff dry immediately to avoid
streaking.
Apply a protective polish to the surface to
maintain luster and protect against food
stains.
Use white vinegar and water to remove
hard water stains.
D E C O R A T I V E R A I L
Clean the decorative hood rail using warm
soapy water. Then hand dry with a clean,
soft cloth.
It is not necessary to remove the decorative
rail from the hood assembly. It should be
cleaned in place.
Be careful not to pull or hang on the bar, as
this could damage the hood assembly.
Dimensions in parentheses are in
millimeters unless otherwise specified.
Be sure that the bulb is cool before
replacing. Halogen bulbs get hot instantly
and adjacent parts may retain heat.
S I G N A T U R E
P O L I S H
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
H E AT L A M P S
Wolf Pro 27" (686) deep wall hoods are
equipped with two heat lamp locations that
require R40, 250W maximum bulbs. Heat lamp
bulbs are not included with the hood.
To replace, turn off the ventilation hood blower
and lights. Once the heat lamp bulb is cool, use
a soft cloth to unscrew the bulb and replace.
Be sure that the heat lamp bulb is cool
before touching.