Sharp EC-S5170 - Manual (Page 11)

11
1
2
STEP
STEP
3
4
CAUTION: Do not use chemicals, bleach or hot water to clean the dirt compartment.
Wash with soap and water using a soft brush. Do not dry with hair dryer or heater.
NOTE: Very fine materials, such as face powder, plaster or fine powder may seal the
filters and cause loss of suction. When vacuuming this type of material, be sure to
empty the dirt compartment and clean the filters more frequently (before reaching the
“Max Fill Line”).
5
Fig.21
Air Duct
6
Fig.22
Fig.23
Fig.24
Empty dirt compartment. (Fig.21)
Replace the net filter assembly into the dirt
compartment.
Be sure to match the marks of the Filter
Compartment and Dust Cup.
Upper Handle Air Duct
Align the projection of net filter assembly
to the slot of dirt compartment and follow
the arrow to fit or turn to CLOSE side.
Align the rectangular groove to the guide
of vacuum cleaner then push to snap
into place. (Fig.24)
OPEN CLOSE
Net Filter
assembly
Projection
Slot
Dirt Compartment
Guide
Rectangular
Groove
Also marks are on Dust Compartment
and Base.
Mark
Mark
2001.12.20, 8:07 AM 11