Sony SCPH-50006 - Manual (Page 25)

25
GB
DVD videos
This product incorporates copyright protection
technology that is protected by method claims
of certain U.S. patents and other intellectual
property rights owned by Macrovision
Corporation and other rights owners. Use of
this copyright protection technology must be
authorized by Macrovision Corporation, and is
intended for home and other limited viewing
uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering
or disassembly is prohibited.
x MPEG
Selects the MPEG AUDIO signals to be output
via the DIGITAL OUT (OPTICAL) connector.
• On : when the console is connected to audio
equipment with a built-in MPEG decoder.
If the console is connected to audio
equipment without a built-in MPEG decoder,
do not turn this option on. Otherwise, when
you play the MPEG sound track, a loud noise
(or no sound) will come out from the
speakers, possibly hurting your ears or
damaging the speakers.
• Off : when the console is connected to audio
equipment without a built-in MPEG decoder.
x Audio Track Auto Select Mode
Gives the audio track that contains the highest
number of channels priority when you play a
DVD on which multiple audio formats (PCM,
Dolby Digital DTS or MPEG AUDIO format)
are recorded.
This setting is not available during Resume
Play.
• On: Priority given
• Off: No priority given
Notes
• If you set this item to “On,” the language may change
because the “Audio Track Auto Select Mode” setting
has higher priority than the “Audio” settings in
“Language Setup” (page 21).
• If you set “DIGITAL OUT (OPTICAL)” to “On” and
“DTS” to “Off” in “Audio Setup”, the DTS audio track
is not played even if you set this item to “On” and the
highest-numbered audio channel is recorded in DTS
format.
• If PCM, DTS Dolby Digital and MPEG AUDIO audio
tracks have the same number of channels, the console
selects PCM, Dolby Digital DTS and MPEG AUDIO
audio tracks in this order.
• Depending on the DVD, the audio channel with
priority may be predetermined. In this case, you cannot
give priority to the DTS Dolby Digital or MPEG
AUDIO format by selecting “On”.
x DVD Volume
If the audio output level of the DVD is low, you
can turn up the volume of the DVD. DIGITAL
OUT (OPTICAL) must be set to “Off” to change
this setting.
• +2: Turns up the volume (maximum).
• +1: Turns up the volume.
• Standard: Original audio volume. Normally
select this position.
Note
If you set this option to “+1” or “+2”, the sound may be
distorted in places where loud sound is present. If the
sound becomes distorted, select "Standard".
Caution
If you turn up the volume too high, your ears may be
injured or the speakers may be damaged.