Sanyo PLC WM5500L - Manual (Page 48)

4
Use the Point ◄► buttons to adjust the gamma value to obtain a
better balance of contrast (from 0 to 15).
Press the Point ◄ button to decrease the sharpness of the image;
press the Point ► button to increase the sharpness of the image
(from 0 to 31).
An interlaced video signal can be displayed in progressive mode.
Press the Point ◄► buttons to change the progressive scan mode.
Off ........... Progressive scan mode is Off.
On ........... Progressive scan mode is On .
Film ......... For watching a film. With this function, the projector
reproduces pictures faithful to the original film quality.
Noise interference on the screen can be reduced. Press the Point
◄► buttons to change the noise reduction mode.
Off ........... Noise reduction mode is Off.
On ........... Noise reduction mode is On.
Note:
• Progressive cannot be selected when 480p, 575p, 720p, or
1080p is selected (p.45).
• Noise reduction cannot be selected with the computer input
and when the video signal format is 1080p. (p.45).
To reset the adjusted data, select Reset and press the SELECT
button. A confirmation box appears and then select yes. All
adjustments will return to their previous figures.
To store the adjusted data, select Store
and press the Point ► or
the SELECT button. Use the Point ▲▼ buttons to select one from
Images 1 to 10 and press the SELECT button.
A confirmation box appears and then select yes. Stored data can
be called up by selecting an Image (1-10) in the Image Mode
Selection on page 46.
A confirmation box
appears and then
select yes.
Store
Video Input
Press the Point ◄ button to lighten red/green/blue tone of the
black level of an image; press the Point ► button to deepen red/
green/blue tone of the black level of an image (from 0 to 63).
Offset(Red/Green/Blue)
Sharpness
Gamma
Noise reduction
Progressive
Reset
Store