Sierra Wireless EV-DO - Manual (Page 121)

Configuration Commands
Rev 3.0B Feb.08 116
• Network Dormant: The PinPoint‐Eis connected to the 1x
cellular network, but the link is dormant. It will be woken
up when data is sent or received.
• No Service: There is no cellular network detected.
• Hardware Reset: The internal module is being reset. This
is a temporary state.
*PRLSTATUS?
• The status of the most recent PRL Update.0 : None
• 1 : In Progress
• 2 : Success
• Any other value : Failure
*POWERMODE?
Displays the current power state/mode. Possible values
returned are:
• Initial: The modem is in the initial 5 minutes since power
up, so power down event will be ignored.
• On: Regular power on, a power down is not pending.
• Low Cancellable: Power down is pending but still
cancelable if the power down trigger goes away.
• Low Pending 1 and Low Pending 2: Power down is
pending, any modem tasks are gracefully preparing for the
power down.
• Low Final: Power down is imminent.
• Low: Power is down.
+HWTEMP?
Displays the internal temperature of the radio module in
degrees Centigrade.
+PRL?
Preferred Roaming List (PRL) version.
Information Displayed in AceManager
without AT Commands Listed
• Bytes and Packets Received and Sent: Network traffic for
the applicable port.
• Number of System Resets: Counter of the number of
system resets over the life of the modem or since the
configuration was reset.
• Bad Password Count: Counter of the number of bad
password attempts.