Sony CPD-E400 - Manual (Page 6)

6
D:\###sagyou\10 gatu\1022\407410412CPDE400_UC\01US03BAS-UC.fm masterpage:Left
CPD-E400
4-074-104-12 (1)
Setup
Before using your monitor, check that the following accessories
are included in your carton:
• Power cord
• Current G3 adapter (for beige system) (1)
• Setup Disk (1)
• Warranty card
• Notes on cleaning the screen’s surface
• This instruction manual
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Note
Do not touch the pins of the video signal cable connector as this might
bend the pins.
x Connecting to an IBM PC/AT or compatible
computer
x Connecting to a Macintosh or compatible
computer
* Connect the supplied Macintosh adapter to the computer before
connecting the cable.
This adapter is compatible with Macintosh LC, Performa, Quadra,
Power Macintosh, and Power Macintosh G3 series computers that have
two rows of pins. If you are connecting to the other version of Power
Macintosh G3 series with three rows of pins or models other than those
stated above, you will need a different adapter (not supplied).
AC IN
1
(HD15)
IBM PC/AT or
compatible computer
to video output
AC IN
1
(HD15)
Current G3 adapter (for beige system)
(supplied)
*
Macintosh or
compatible computer to video
output
01US01COV-UC.book Page 6 Friday, October 22, 1999 10:19 AM