Sunrise Medical POWERTEC F50 - Manual (Page 11)

Issue 4 8
Preparing your wheelchair for use
Fitting the batteries
Your Sunrise wheelchair batteries
are located in two battery boxes.
With your powerbase fully
assembled, drop the battery boxes
into the centre of the powerbase. It
is important to note that there is a
left and a right hand battery box.
The easiest way to remember
which battery box locates where, is
to ensure that the curved side
panel of each battery box forms a
natural wheel arch to the rear
wheels.
Locate securely, the battery boxes
and lid clips. Take the leads from
each battery box and connect
together.
Connect battery socket on Battery
loom to socket on loom coming out
of rear chassis moulding.
Attaching the rear view mirror
1. Firstly set the Pilot Plus remote
pod arm into the desired
position.
2. Place the metal clamp over the
remote arm, between the adjust
bracket and the rubber gaiter of
the pilot plus swing-away. The
holes must be toward the
outside of the chair.
3. Place the mirror through the
clamp holes and then, using the
locking handle, begin to tighten
the mirror in position.
4. The mirror should stand
vertically once in position but
can be subsequently adjusted by
slackening off the locking
handle, adjusting the mirror and
then re-tightening.
Fig. 2
Battery
box clip
Connecting
plugs
Fig. 3