Sanyo ICR-B50 - Manual (Page 3)

2
WHAT TO DO IF...
If the operation of the unit or display is not nor-
mal,
1. Open the battery compartment lid.
2. Remove the batteries. Wait 2 minutes, then
reinstall the batteries.
3. Press the reset switch (back of the unit) using a small ball-point pen,
etc. (Fig. 1)
4. Resume operation.
PRECAUTIONS
• If the line of rectangles in the battery indicator ( ) disappear during
recording, stop the recording immediately and replace the batteries.
• Do not disconnect the AC adaptor or remove the batteries while operating
the unit.
• Before erasing, make sure that the battery indicator is full.
• The apparatus should not be exposed to dripping or splashing.
• Do not insert pins, etc., inside the unit.
• Do not drop the unit or subject it to strong shocks.
• Do not use where there are extremes of temperature (below 5
°
C (40
°
F)
or exceeding 35
°
C (95
°
F)).
Fig. 1
ACCESSORIES
Audio cable x 1
CD-ROM x 1 Parallel port adaptor x 1
Case x 1
Important Information:
Because its products are subject to continuous improvement, SANYO re-
serves the rights to modify product designs and specifications without
notice and without incurring any obligation.