Sherwood RV-4060R - Manual (Page 4)

INSTALLATION
SPEAKER POSITIONING
1 4. VIDEO IN/OUT
– VCR 1 IN/OUT – PLAY(input) and REC(output) jacks for
connecting the video output and input of a VCR.
– MONITOR OUT – output jack for connecting to the
video input of a TV set. The TV set must then be
switched to that input.
1 5. SUBWOOFER – output jacks for driving subwoofer.
Connect this jack to SUBWOOFER input jack of a
separate amplifier or a powered SUBWOOFER.
1 6. DIGI LINK III SYSTEM CONTROL
(colored green) – remote control jacks for connection to
the corresponding DIGI LINK
II or III jacks of a
Sherwood CD (Compact Disc) or tape player.
Connect this jack to the DIGI LINK
III jack of the external
Sherwood equipment that uses the DIGI LINK II or III
remote control system.
These jacks have been added to maintain compatibility
with other Sherwood products.
1 7. REAR SPEAKERS
Terminals for connecting a pair of rear speakers,
impedance of 4
Ω
each, to obtain a surround sound
effect.
Note : Always connect two speakers to these terminals.
1 8. CENTER SPEAKER
Terminals for connecting a center speaker, impedance
of 8
Ω
.
1 9. FRONT SPEAKERS
Terminals for connecting a pair of main speakers,
impedance of 8
Ω
(L = left, R = right).
One of the wires of a speaker cable is marked with a
color or rib. Connect the marked wire to the red
terminal, the non-marked wire to the black one.
POWER
10. AC POWER CORD
Connecting the receiver to the wall socket.
11. OUTLET
- Switched output for connecting AC power plugs from
various units such as cassette deck, CD player, etc.
(Maximum total capacity is 1 A or 100 W)
Power off mode : Switched AC outlet off
Power on mode : Switched AC outlet on
CONNECTING HEADPHONES
Connect a headphone with a 1/4"
plug to the PHONES jacks.
– Inserting the plug will not
disconnect the speakers.
– Only in surround off mode, you
can enjoy private listening with a
headphone.
SPEAKER POSITIONING
To obtain the best surround sound effect in your home,
place the speakers as shown below.
The left and right speakers should be about 1 m (40") from
the TV set.
The center speaker should be above or below the TV set.
The rear speakers should be placed 2~3 feet above the ear
level of a seated listener on the direct left and right of them.
Refer to the fold-out for additional information.
Note : to avoid interference with the TV picture, use only
magnetically shielded front speaker systems.
After making all necessary connections (some may not
apply to your system set-up), your system is ready for use.
In the next chapter, we will describe how to operate your
RV-4060R receiver.
4
LEFT
TV
RIGHT
CENTER
SPEAKER
SURROUND
LEFT SURROUND
RIGHT
ENGLISH
MEMO MEMO
PHONES PHONES