Sterling Trucks Acterra MX - Manual (Page 18)

IMPORTANT: At each Maintenance Operation Set, in
addition to the maintenance operations listed in this
table, perform all daily, weekly, and monthly mainte-
nance operations listed in the "Pretrip and Post-trip
Inspections and Maintenance" chapter of the
Acterra
® Driver’s Manual.
NOTE: Maintenance operations appearing in italics in
this table are for noise emission control components.
Numbers in this table are maintenance operation ref-
erence numbers matching those in the text of this
manual.
Maintenance Operation Sets for Groups 00 through 83
REQUIRED MAINTENANCE OPERATION SET IM M1 M2 M3 M4 M5
Maintenance Operation Number and Operation Description
01–01 Engine-Support Fasteners Checking • •
01–02 Engine Drive Belt Inspecting • • •
01–03 Pacbrake Inspecting and Maintenance * • • •
09–01 Air Cleaner Element Inspecting and Replacing • • •
13–01 Air Compressor Inspecting, Bendix • • •
13–02 Air Compressor Rebuilding/Replacing, Bendix •
15–01 Alternator, Battery, and Starter Checking • •
20–01 Radiator Cap Checking • • • •
20–02 Radiator Pressure Flushing and Coolant Changing • •
20–03 Fan Clutch Checking • • • •
25–01 Clutch Release Bearing and Release Cross-Shaft Lubricating • • • • • •
25–02 Clutch (Pull-Type) Inspecting and Adjusting • • • •
25–03 Hydraulic Fluid Level Checking • • • • •
25–04 Hydraulic Fluid Replacing •
26–01 Manual Transmission Fluid Level Checking • • •
26–02 Eaton Fuller and TTC Transmission Fluid Changing and Magnetic Plug Cleaning • † • •
26–03 Allison, Eaton Fuller, and Meritor Transmission Breather Checking • • • •
26–04 Allison Transmission Fluid and Filter Changing • • •
26–05 Mercedes-Benz Transmission Fluid Changing and Magnetic Plug Cleaning •
26–06 Mercedes-Benz Transmission Leak Checking •
31–01 Frame Fastener Torque Checking • • •
31–02 Fifth Wheel Inspecting • • • • • •
31–03 Fifth Wheel Lubricating • • • • • •
31–04 Trailer Electrical Connector Lubricating • • • • • •
32–01 Suspension Inspecting • • • • • •
32–02 Suspension Lubricating • • • • • •
32–03 U-Bolt Torque Checking • • • •
33–01 Knuckle Pin Lubricating • • • • • •
33–02 Tie-Rod End Inspecting • • • • • •
33–03 Tie-Rod End Lubricating • • • • • •
General Information
00
Maintenance Operation Sets Table: 00–08
Acterra Maintenance Manual, October 2008 00/11