Samsung SHR-1040K - Manual (Page 45)

SHR-1040/1040K USER’S MANUAL
English 6-7
(1) EVENT RECORD ENABLE
Set the EVENT RECORD ENABLE to ‘On’ to start recording when alarm occurs, and set the EVENT RECORD
ENABLE to ‘Off’ to not start recording when alarm occurs. If you exit the menu after setting the EVENT RECORD
ENABLE to ‘On’, the system records data whenever an alarm occurs.
The following screen shows that the system records a program after an alarm occurs. The ‘A’ mark before the title of
the channel indicates that an alarm occurred.
[ON/OFF]
(2) PRE ALARM TIME LIMIT
- The Pre Alarm Time Limit enables users to know the state of the system before a motion is detected
or an alarm occurs. It decides the length of time for recording video and audio data input right before
motion or alarm. The system always stores 0 to 5second-long video and audio data in the memory,
and records data during the pre-set time set by the Time Limit in HDD when alarm recording starts.
[ 0, 1SEC, 2SEC, 3SEC, 4SEC, 5SEC ]
(3) POST ALARM TIME LIMIT
- After recording data as set by the MAIN ALARM TIME, the system records additional sec-
onds as set by the POST ALARM TIME Limit.
[10SEC ,20SEC ,30SEC ,1MIN ,2MIN ,3MIN ,4MIN , 5MIN]
7
Event Record Mode Setup
● The default settings of the Alarm/Motion Recording Setup menu are shown as follows.
SHR-1040/SHR-1040K-ENG 2006.4.4 11:12 AM ˘ ` 5-7