Operation, Water supply indicator light, Adjustment of sensor detection sensitivity – Sharp ENGLISHFRANAISESPAOL KC-860U User Manual

Page 16: Lights control button

Advertising
background image

E-14

OPERATION

WATER SUPPLY INDICATOR LIGHT

When the Water Tank is empty, the Water Supply Indicator Light will fl ash

to indicate that the Water Tank should be refilled. Please note the light

will not fl ash even when the Water Tank is empty during the Clean Air

Mode and the Quick Clean Mode.

Sound indicator setting for water supply.

In addition to the Indicator Light, the unit can be set to signal

with an audible beep when the Water Tank is empty. With the

unit OFF, press the Lights Control button for 3 seconds to turn

the audible signal ON.

Cancellation
To cancel the audible signal, with the unit OFF, press the Lights

Control button again more than 3 seconds.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to ‘low” if the DUST MONITOR is constantly red to reduce sensitivity, and set to

‘high’ if the DUST MONITOR is constantly green to increase sensitivity.

1

With the unit OFF, press the Fan Speed Button for 3 seconds.

The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The

factory setting is Standard, indicated by the MED light.

2

Press the Fan Speed Button to set

the desired sensor sensitivity.

Refer to the diagram on the right to select the

desired sensor sensitivity level.

3

Press the Power OFF Button.

Note that if the Power OFF Button is not pushed

within 8 seconds of adjusting sensor sensitivity,

the setting will be saved automatically. The sen-

sor sensitivity setting will be saved even if the

unit is unplugged.

Sensor Detection

sensitivity

Fan Speed

Indicator Light

High

Standard

Low

Use when the light on the

front panel is too bright.

Refer to the diagram to select the desired

brightness on the front panel.

CAUTION

The lights on the front monitor are always brighter when starting.

The lights on the front panel are brighter.

The lights on the front panel are darker.

The lights on the front monitor turn off.

LIGHTS CONTROL Button

Advertising