Stanley GT 18B01 - Manual (Page 11)

11
CONTROL PANEL
RETURN PRESSURE
H.T.M.A. 1/2 INCH MALE
QUICK DISCONNECT
COUPLER
H.T.M.A. 1/2 INCH FE-
MALE QUICK DISCON-
NECT COUPLER
1/2 INCH I.D. HOSE, 25 FT
LONG WITH 2500 PSI/
172 BAR RATING AND
4 TO 1 SAFETY FACTOR
PRESSURE
RETURN
1/2 INCH MALE PIPE HOSE END
1/2 INCH MALE PIPE HOSE END
ADAPTER, 3/8 INCH MALE PIPE x
-8 SAE O-RING
H.T.M.A. 1/2 INCH MALE
QUICK DISCONNECT
COUPLER
H.T.M.A. 1/2 INCH FE-
MALE QUICK DISCON-
NECT COUPLER
TOOL RETURN
Figure 2. Hydraulic Connections
DO NOT OVERTIGHTEN THE FITTINGS.
5. BATTERY
The supplied 12 Volt DC battery is a non-spillable, mainte-
nance-free battery and is fully charged.
Make sure the battery cables are tight and charging circuit
functions are operating properly.
OPERATION
Do not charge the battery with a standard auto-
motive battery charger. This type of charger pro-
duces a charging amperage higher than 2 amps.
Charging the battery at higher than 2 amps will
damage the battery.
NOTICE
NOTICE
If the engine runs out of gas or dies during op-
eration and the ignition switch is left in the ON or
RUN position, this could drain the battery. Make
sure the ignition switch is returned to the OFF
position.
PRESSURE