Sub-Zero Freezer User Manual
Page 20
S I D E P A N E L I N S TA L L AT I O N O P T I O N S
Dimensions in parentheses are in
millimeters unless otherwise specified.
20
S I D E PA N E L
I N S T A L L A T I O N
If you’re installing a Built-In model with side
panels, check with your installer or use one of
the following Side Panel Installation Options.
Drill three holes equidistant in a vertical
section of the aluminum frame, and install pan
head screws. Do not drill through model and
serial number plate. Anchor the side panel
with decorative screws or finishing nails from
a local hardware store. Do not use adhesives.
Refer to illustration 16 below.
The dimensions given in the Side Panel
Installation Options are for typical wood side
panels. If a
1
/
4
" (6) thick or less panel is used
and inserted into the return channel extrusion,
then a 24
1
/
4
" (616) wide panel is necessary. In
this application, the panel must be notched for
the grille and other brackets or screws that are
in the return channel. Toe kick cut-outs will be
necessary for all side panel applications. Refer
to illustration 17 below.
IMPORTANT NOTE: The use of side panels
may change the width of your rough opening.
IMPORTANT NOTE: The overall height on the
side panel will vary with the height of the grille
being used. Make sure you know your finished
height before cutting any panels.
C O M P L E T I N G
T H E I N S T A L L A T I O N
24"
(610)
24"
(610)
24
1
/
4
"
(616)
FRAME
1/4" (6) THICK SIDE PANEL FITTED IN TO UNIT FRAME
1/8" (3) THICK BATTENS
DOOR PAN HEAD SCREW
SIDE OF SUB-ZERO UNIT
1/4" (6) SIDE PANEL MATERIAL
FRAME
3/8" (10) THICK SIDE PANEL FITTED UP TO UNIT FRAME
1/8" (3) THICK BATTENS
DOOR PAN HEAD SCREW
SIDE OF SUB-ZERO UNIT
3/8" (10) SIDE PANEL MATERIAL
24"
(610)
FRAME
METAL SIDE PANEL FITTED UP TO UNIT FRAME
DOOR PAN HEAD SCREW
SIDE OF SUB-ZERO UNIT
METAL SIDE PANEL MATERIAL
24"
(610)
FRAME
1/2" (13) THICK SIDE PANEL FITTED UP TO UNIT FRAME
1/8" (3) ROUT
DOOR PAN HEAD SCREW
SIDE OF SUB-ZERO UNIT
1/2" (13) SIDE PANEL MATERIAL
FRAME
1/4" (6)
THICK BATTENS
DOOR PAN HEAD SCREW
SIDE OF SUB-ZERO UNIT
1/4" (6) SIDE PANEL MATERIAL
1/4" (6) THICK SIDE PANEL FITTED UP TO UNIT FRAME
1/8" (3) THICK BACK-UP
2
1
/
2
"
(64)
W
3"
(76)
1
/
4
"
(6)
1
/
4
"
(6)
3"
(76)
4"
(102)
13
1
/
4
"
(337)
DOOR
FRAME
SIDE PANEL
PAN HEAD
SCREW
1
1
/
8
"
(29)
Illus. 16
Illus. 17
Top Views