Sub-Zero Freezer - Manual (Page 22)

Dimensions in parentheses are in
millimeters unless otherwise specified.
22
I N S TA L L AT I O N C H E C K L I S T
The importance of the installation of the
Sub-Zero Built-In unit cannot be overempha-
sized. Proper installation is the responsibility
of the selling dealer or installer.
IMPORTANT NOTE: To ensure a safe and
proper installation, the following checklist
should be completed by the installer to ensure
that no part of the installation has been over-
looked.
Any questions or problems about the installa-
tion should be directed to your Sub-Zero
dealer or the Sub-Zero Customer Service
Department at 800-222-7820 or e-mail
[email protected]. You can also
visit our website at subzero.com.
C O M P L E T I N G T H E I N S T A L L A T I O N
9 0 D E G R E E D O O R S TO P
The doors of all Built-In models open to 130
degrees. For Models 601R, 601RG, 601F, 661,
642, 685, 632 and 695, optional 90˚ or 105˚ door
stop kits are available through your Sub-Zero
dealer.
Models 611, 611G, 650 and 650G come with
a door stop pin to limit the door swing to 90
degrees. To install the door stop pin for
Models 611 and 650, remove the pin from the
plastic package located behind the grille and
insert it into the space provided on the top
hinge plate. Tighten with a screwdriver. Refer
to illustration 22 below.
For Models 611G and 650G, remove the
door stop pin from the plastic package located
behind the grille and insert it into the space
provided on the lower hinge plate. Tighten
with a screwdriver. Refer to illustration 23.
Illus. 22 Illus. 23