The control elements of the s, Tereo, Italizer – Sound Performance Lab 9320 User Manual
Page 11
11
S T E R E O
The control
elements of the
S
TEREO
V
ITALIZER
®
The V
ITALIZER
A
CTIVE
function switches the S
TEREO
V
ITALIZER
on or off. The
status LED indicates that the S
TEREO
V
ITALIZER
has been activated.
The V
ITALIZER
A
CTIVE
function is a relais-hard-bypass function. In the event
of a power failure the S
TEREO
V
ITALIZER
is automatically switched to hard-
bypass (power failure safety).
To increase the operational safety of the monitor loudspeakers you
should not switch the S
TEREO
V
ITALIZER
on or off at high monitor volume. At
high amplitudes inside the filter, there may be residual charges on the swit-
ching contacts which may be discharged when you switch over. These may
become apparent as audible click sounds. If applicable, reduce or mute the
monitor loudspeakers before switching on or off.
The input stages of the S
TEREO
V
ITALIZER
are equipped with P
EAK
LEDs
which light up around 3 dB before the effect signal path is potentially over-
driven. Make sure that the P
EAK
LEDs only light up briefly, if at all. It is
essential to avoid the P
EAK
LEDs being lit up for any length of time. If they
do so, reduce the input level or switch from L
OW
to H
IGH
on the rear of the
unit.
The B
ASS
control is responsible for the »colour« of the bass sound your
signal is to have. If you move the B
ASS
control to the right, you get a drier,
percussive bass sound, known as T
IGHT
. As a result of this, on the right-
hand side of the scaling points, there are squares which increase in size, in
line with increased intensity. They symbolize the contoured »T
IGHT
« bass
sound.
If the B
ASS
control is moved from the centre position (0) to the left, the
bass sound becomes very deep, soft and warm. This sound is known as
S
OFT
. This is symbolized with round scaling points which also increase in
size as the intensity increases.
The further the B
ASS
control is shifted to the right or left of the centre
position, the more intensive the bass sound in question. However, P
ROCESS
must be positioned to the right of the MIN setting for the bass to be
audible.
You can always hear the original (dry) bass if the B
ASS
control is in a
centre position.
Vitalizer
Active
Bass
3
2
1
5
6
3
2
4
7
8
1
Peak