Smeg FP850APZ - Manual (Page 20)

Instructions for the User
45
12.EXTRAORDINARY MAINTENANCE
Occasionally, the oven will require minor servicing procedures or the replacement of parts subject to
wear and tear, such as gaskets, light bulbs, etc. The specific operations for each procedure of this kind
are provided below.
Before carrying out any operation involving access to live parts, disconnect the appliance from the
electricity supply.
12.1 Changing the light bulb
Remove the protective cover A by unscrewing it anticlockwise and replace the bulb B with another of the
same type. Replace the protective cover A.
Use only light bulbs approved for ovens (T 300°C).
12.2 Removing the door
12.2.1 With type 1 mobile levers
With the door completely open, lift the levers A of the two
hinges until they touch the hinges B and take hold of the two
sides of the door with both hands close to the hinges
themselves. Raise the door to an angle of about 45° and
remove it. If the hinges have not locked, repeat the operation,
raising the levers and keeping the door slightly raised. To
reassemble, fit the hinges B into their grooves, then lower the
door into place, ensuring that it remains fitted into the grooves
C, then lower the levers A.
1)
12.2.2 With type 2 mobile levers
Lift the levers B and take hold of the two sides of the door with
both hands close to the hinges A.
Raise the door to an angle of about 45° and remove it. To
reassemble, fit the hinges A into their grooves, then lower the
door into place and engage the levers B.
2)
12.2.3 Removing doors with pins
Open the door completely and insert the pins (supplied) into the holes from the inside. Close the door to
an angle of about 45° and lift it off. To reassemble, fit the hinges into their grooves, then lower the door
into place and extract the pins.