Sony IPELA SNC-RH124 - Manual (Page 48)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network Menu
48
EAP: Select for EAP authentication. When this option
is selected, enabling the 802.1X (wireless) function
is required. After selecting EAP, click OK at the
bottom of the window. The 802.1X function is
enabled.
Note
For correct operation of the 802.1X function, you need
to configure the 802.1X settings, such as certificate
setting, appropriately. For details on the 802.1X settings,
see “Using the 802.1X Authentication Function —
802.1X Menu” on page 56.
802.1X
This button is active when EAP is selected on
Authentication.
When you click 802.1X, the 802.1X menu appears,
allowing you to configure the 802.1X (wireless)
function.
Passphrase
Set a passphrase when PSK is selected on
Authentication.
Type 8 to 63 ASCII characters (alphanumeric), or up to
64 hexadecimal digits (0 to 9 and A to F).
Re-type passphrase
To confirm the passphrase, retype the passphrase that
you typed in the Passphrase box.
Simple setting
Set up this item when Simple setting is selected on
Security.
You can easily connect to an access point compatible
with WPS.
Note
This function is available for certain models only.
OK/Cancel
See “Buttons common to every menu” on page 29.
QoS Tab
In the QoS tab, traffic priority can be set by configuring
the number, network address, subnet (prefix), port,
protocol and/or DSCP of IPv4 or IPv6.
A maximum of 10 addresses (No.1 to No.10) can be
registered.
IPv4 QoS setting
Select On to configure the QoS setting for IPv4.
Rule
Used to register, edit and delete QoS.
No.
Select the number to use when registering on the QoS
table.
When you select a registered number, the registered QoS
information is displayed.
Network address
Enter the address to perform QoS.
Subnet
Enter the subnet mask.
Port
Enter the port number.
Protocol
Select the protocol.
DSCP
Enter the DSCP value.