Sony 76c - Manual (Page 66)

66 Fine-tuning the Projector
Setting a Password
1. Press the Freeze button on the remote control for about 7 seconds
until you see the Password Protect menu:
2. Select Password and press Enter . You see the message Change
the password?
3. Select Yes and press Enter .
4. Hold down the Num key on the remote control and use the
numeric keypad to enter a 4-digit password.
The password will be displayed as **** . After you enter the last
digit, a confirmation screen appears. Enter the password again.
5. After you finish setting the password, press the Esc button to
return to the Password Protect menu.
Make a note of the password and keep it in a safe place in case you
forget it.
Turning On the Password and User’s Logo
1. Press the Freeze button on the remote control for about 7
seconds until you see the Password Protect menu.
2. To enable the password, select Power ON Protect and press
Enter . Select ON then press Esc .
3. If you want to disable the password temporarily, select Timer and
press Enter . Then hold down the Num button while you use the
numeric keypad to enter the number of hours (from 0 to 9999)
that you want the password feature disabled. If you want the
projector to request the password every time it is turned on, set
the timer to
0H .
note
If a password has already
been set, you see the
Password Protect Release
screen. See “Starting the
Projector with a Password”
on page 67.
Use these buttons like a
numeric keypad to enter
the password
Hold down this button to
activate the numeric
keypad