Sony CPD-G500 - Manual (Page 5)

5
US
Identifying parts and controls
See the pages in parentheses for further details.
1 RESET (reset) button (page 16)
This button resets the adjustments to the factory settings.
2 INPUT (input) switch (page 8)
This switch selects the HD15 or BNC video input signal.
3 Control button (page 10)
The control button is used to display the menu and make
adjustments to the monitor, including brightness and contrast
adjustments.
4 1 (power) switch and indicator (pages 7, 16, 20)
This button turns the monitor on and off. The power indicator
lights up in green when the monitor is turned on, and either
flashes in green and orange, or lights up in orange when the
monitor is in power saving mode.
5 AC IN connector (page 7)
This connector provides AC power to the monitor.
6 Video input 1 connector (HD15) ( y 1) (page 6)
This connector inputs RGB video signals (0.700 Vp-p,
positive) and sync signals.
* DDC (Display Data Channel) is a standard of VESA.
7
Video input 2 connector (BNC) (
y
2) (page 6)
This connector inputs RGB video signals (0.700 Vp-p,
positive) and sync signals.
MENU
RESET INPUT HD15 BNC
MENU
RESET INPUT HD15 BNC
R G B HD VD
(HD15) (BNC)
AC IN
Rear Front
rear side
forward side forward side
rear side
Pin No. Signal
1 Red
2 Green
(Sync on Green)
3 Blue
4 ID (Ground)
5 DDC Ground*
6 Red Ground
7 Green Ground
8 Blue Ground
9 DDC + 5V*
10 Ground
11 ID (Ground)
12 Bi-Directional Data (SDA)*
13 H. Sync
14 V. Sync
15 Data Clock (SCL)*
5 4 3 2 1
6 7 8 9 10
11 12 13 14 15