Samsung CHT-420 - Manual (Page 27)

49 48
Volume light
Speaker Volume Control
1 Open “MENU”
With the DVD in stop mode, press the MENU button.
2 Select “Install”
Using the up/down and left/right buttons, move the selection cursor
to “Installation”, then press ENTER to select.
3 Select “Volume light”
Move the selection arrow to “Volume light”, then press right to
select from the following options.
• Auto - Volume light (light surrounding main unit volume control)
will be turned off automatically.
• On - Volume light will be bright all the time.
1 AMP Volume Control
• Connect the speakers to the speaker jack on the rear.
• When you turn the power ON, if the last volume level was over
20, the volume will be set to 20, and if it was under 20, the
volume will be set to that level.
2 Headphone Volume Control
• You can adjust the volume by connecting the headphone to the
Headphone JACK on the front panel.
• The speakers will be muted.
• The LINE OUT AUDIO will be output continuously while the
Headphone is connected.
MAIN MENU
Installation
RETURN ❷ ENTER
Program Clock Install Exit
DVD VCR Options Language
Install
INSTALLATION
Channel setup
❿ Volume light : [Auto]
RETURN ❷ ➛ ❿
Auto
On
Connect the front, center, and surround speakers and the
subwoofer to the speaker terminals on the back of the main unit.
1 Connect the speakers to the speaker output terminals on the back
of the main unit, matching the colors.
Caution
Do not set the Speakers (except center speaker) near the TV or Monitor
because they are not magnetic shielded.
Connecting the Speakers
RADIO ANT.
DVD Olny
COMPONENT VIDEO OUT
SPEAKERS
AM
FM
75
COAXAL
S-VIDEO OUT
CENTER SURROUND L FRONT L
WOOFER SURROUND R FRONT R
IN (FROM ANT.)
OUT (TO TV) RF
VIDEO
AUDIO
DVD & VCR
LINE
IN 1 LINE
IN 2 LINE
OUT
R
L
SPEAKERS
CENTER SURROUND L FRONT L
WOOFER SURROUND R FRONT R
Center Speaker
Center Speaker
Front Speaker (R)
Front Speaker (L)
Subwoofer
Subwoofer
Surround
Speaker (L)
Surround
Speaker (R) Surround
Speaker (L)
Surround
Speaker (R)
Front
Speaker (L)
Front Speaker (R)