Sony RM-AV2500 - Manual (Page 33)

33
3
Press the desired Component
Select button.
The selected component name stays
lit and “LEARN” flashes.
4
Press and hold down the button
on the component’s remote
control (amplifier in this example)
until you hear a beep.
(If you release the button before
you hear a beep, the signal may
not be learned correctly.)
“LEARN” stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4
again.
5
Press COMMANDER OFF.
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press CHANNEL + and VOLUME +.
2 While pressing the LIGHT button,
press the Component Select button
which you want to clear.
Notes
• You can program a signal by “learning” for a
Component Select button for which a System
Control function (page 27) or the Power-On
function (page 30) has been programmed. In
this case, the System Control function or the
Power-On function is overwritten and cannot
be used. If you clear the “learned” signal
from the button, the System Control function
or the Power-On function is resumed, and
you can use it again.
• You cannot program a System Control
function (page 27) for a Component Select
button for which a signal has been
programmed by “learning.”
• You can program the Power-On function for
a Component Select button for which a signal
has been programmed by “learning,” but
then the Power-On function cannot be used.
If you clear a “learned” signal from the
button, you can use the Power-On function.