Smeg SCP111NE2 - Manual (Page 13)

50
Instructions for the user
7.7.2 Automatic cooking
Automatic cooking is the function which allows a cooking operation to be started at a
set time and then ended after a specific length of time set by the user.
Select a cooking function, set the cooking temperature required or leave the
preset temperature (see paragraph “7.6 Selecting a function”) and press
PT1 twice. The display will show the figures and the symbol
(flashing).
Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to
23:59).
For safety reasons, when setting automatic cooking the user must first
program a cooking duration and then set the cooking start time. It is not
possible to set the cooking start time only, without setting the cooking
duration.
After setting the duration, press PT1 once.
The symbol and the current time will appear on the display.
Turning PT1 to the right increases the time, allowing the cooking start time
required to be set.
A few seconds after the required duration is set, the and symbols will
stop flashing, and the oven will start to wait for the starting time set. At the
end, the word STOP will appear on DSP1, cooking will stop and a buzzer will
sound; press PT1 once to deactivate it.
If you wish to continue cooking beyond the set time, press PT1 again. The oven will
restart normal operation with the temperature settings selected previously.
PT2 has to be pressed to switch the oven off completely.
Modifying the data set
Once automatic cooking has started, its duration can be changed.
When the and symbols are steady and cooking is in progress, or the
oven is in stand-by status waiting for cooking to start, press PT1 once. The
symbol starts flashing and PT1 can be turned to change the set duration.
Press PT1 again; the symbol goes out, the symbol will start to flash,
and the cooking start time will be displayed on DSP1. The cooking start time
can be increased or decreased by turning PT1.
A few seconds after the last change, the and symbols will appear (in
steady mode) on DSP1 and automatic cooking will restart with the new
settings.
Once cooking has been programmed, before it starts, the function symbol will remain
on, as will the symbols , .