Scag Power Equipment GC-STWC-61V - Manual (Page 5)

3
12. Install the hopper mounting brackets to the
outside of the frame on the rear of the machine.
See Figure 3-6.
FIGURE 3-6
13. Attach the hood assembly to the machine by
installing the mounting post into the hopper
mounting brackets. Secure with the ring pins
and tighten the locking bolts. See Figure 3-7.
FIGURE 3-7
14. Install the hose from the blower assembly
adapter to the hopper hood and secure using the
8-1/2" clamps.
15. Install the bag assemblies.
7. Install the blower assembly to the mounting
bracket and secure with the mounting pin.
See Figure 3-4.
8. Align the blower assembly with the discharge
opening of the cutter deck. Tighten the
hardware for the mounting bracket. See Figure
3-4.
9. Install the quick pin through the rear hole in the
discharge chute mounting bracket. See Figure 3-
4.
FRONT SIDE
IDLER PULLEY
BACK SIDE
IDLER PULLEY
BLOWER
PULLEY
SPINDLE
PULLEY
10. Install the belt to the spindle pulley. When
replacing the belt, see figure 3-5 below.
FIGURE 3-4
11. Install the new belt covers and secure. See
items number 1 and number 21 on page 10 of the
Blower Mounting Components section in the
Illustrated Parts List for proper installation.
Figure 4 A GC-STT Install Art
Hopper
Mounting
Brackets
Rear Frame
Ring Pins
Ring Pins
Locking
Bolts
Locking
Bolts
FIGURE 3-5
16. Using the weight support bar as a guide, identify
the four corresponding mounting holes, and the
existing hardware that will need to be removed in
order to secure the weight support bar to the
front of the machine as shown. See Figure 3-8,
Page 4.
RIGHT SIDE OF
CUTTER DECK SHOWN
(Note: Some parts not shown for viewing purposes.)
2006 GC-STC-V install art 3
BLOWER
ASSEMBLY
MOUNTING
BRACKET
MOUNTING PIN
TIGHTEN MOUNTING
BRACKET HARDWARE
HAIR
PIN
QUICK
PIN