Woodstock 13 1/4" Oscillating Drill Press W1668 - Manual (Page 32)

-30-
W1668 13 1 ⁄
4
" Oscillating Drill Press
M
A
INTE
N
A
N
CE
SHOP FOX Drill Press Vises use precision ground steel guide rods,
smooth-action Acme threads, ground steel jaws, with fixed jaw
V-grooves for holding round stock, and dovetailed ways where appli-
cable.
D2727 SHOP FOX ® (3" Basic Vise)
D2728 SHOP FOX ® (4" Basic Vise)
D2729 SHOP FOX ® (6" Basic Vise)
D2933 SHOP FOX ® (3 3 ⁄
4
" Angle Vise)
D2730 SHOP FOX ® (3" Cross Sliding Vise)
D2731 SHOP FOX ® (4" Cross Sliding Vise)
The 4" PRO-STIK ® Stick with Handle is the easiest solution for increas-
ing the life of sanding sleeves by removing pitch and sawdust particles
from the abrasive pores, which later harden in place if not removed. Simply
press the cleaner lightly against the moving abrasive surface to remove
clogged-up pitch and sawdust. PRO-STIK ® cleaners are available in other
sizes for any cleaning application that would need cleaners with handles,
as blocks, or as flat pads. (Not recommended for wide-belt sanders.)
The following drill press accessories may be available through your local Woodstock International Inc.
Dealer. If you do not have a dealer in your area, these products are also available through online deal-
ers. Please call or e-mail Woodstock International Inc. Customer Service to get a current listing of deal-
ers at: 1-800-545-8420 or at [email protected].
D2677 Drum Sander Set includes three rubber sanding drums 4 1 ⁄
4
"
in length to accommodate 1", 1 1 ⁄
2
" and 2" diameter sanding sleeves.
This kit also includes one 80 grit sleeve for each drum to get things
started.
D2722 Mandrel is a
3 ⁄
8
" shank and is required to use our Drum Sander
Set with any machine. Mandrel is included with the SHOP FOX®
Oscillating Drill Presses featured above.
Drill Press Clamps adjust quickly and easily to lock your workpiece
in any position. The clamping pad pivots to conform to any workpiece,
ensuring uniform pressure.
W1301 6" Drill Press Clamp (1 1 ⁄
2
" Capacity)
D2192 10" Drill Press Clamp (3" Capacity)
D2493 12" Drill Press Clamp (5" Capacity)
Sanding Sleeves are sized to fit the D2677 Drum Sander Set. These hard
Sanding Sleeves are available in 60, 80, 100, 120, and 150 grits. Keep
plenty of these consumable Sanding Sleeves on hand.
Drill Press Accessories
Sanding Sleeves
Size
(Dia. x Ht.) 60 Grit 80 Grit 100 Grit 120 Grit 150 Grit
1" X 1 ⁄
4
" D2683 D2684 D2685 D2686 D2687
1 1 ⁄
2
" X 1 ⁄
4
" D2688 D2689 D2690 D2691 D2692
2" X 4 1 ⁄
4
" D2693 D2694 D2695 D2696 D2697