Samson DMS80 - Manual (Page 9)

C O N T R O L S A N D F U N C T I O N S
9
Rear Panel
1 7 6 5 4 3 2
SPEAKER OUTPUTS
LEFT+ LEFT- RIGHT+ RIGHT-
SPEAKER IMPEDANCE 8 Ω LINE IN AUX/CD IN
SAMSON DESKTOP MONITOR SYSTEM STEREO 40W X2 MODEL:DA80
LINE OUT SUB OUT
SERIAL
NUMBER
RISK OF ELECTRIC SHOCK DO NOT OPEN
WARNING DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE AVIS RISQUE DE CHOC ELECTRONIQUE NE PAS OUVRIR
CAUTION FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE ATTENTION UTILISER UN FUSIBLE DE RECHANGE DE MÊME TYPE
RIGHT LEFT RIGHT LEFT RIGHT MONO LEFT
1. SPEAKER OUT
This push-spring terminal strip is the amplified output which powers
the speakers. Any non-amplified speakers may be used as long as
they are rated to meet a 6 ohm to 8 ohm impedance. There will be
no output when headphones are inserted into the headphone jack.
CAUTION: Be sure power to the DA80 is off before connecting the
speakers. Be sure none of the wire strands make contact with other
speaker terminals or the DA80’s protection circuitry will shut that
channel down and no sound will be heard until the wire is removed.
NOTE: Plugging headphones into the front panel headphone jack
will mute any signal to the SPEAKER OUTPUTS as well as to the
SUB OUT MONO output.
2. LINE IN
The LINE IN jacks accept audio signal input from any equipment
with line level outputs. This will include any keyboard or sound mod-
ule, line level from any mixer or the output of your computer’s sound
processing board. Use the provided shielded cable accessory for
connection. There is no separate volume for the LINE IN, so adjust-
ments to the equipment connected to the LINE IN jacks may be
necessary to balance them with equipment plugged into other
inputs.
ENGLISH