Smart Technologies Smart Projector UF75/UF75w - Manual (Page 5)

5 | KNOWLEDGE BASE – MAINTAINING YOUR SMART UF75 OR UF75W
PROJECTOR
9. Use the same attachment to vacuum the vents on either side of the projector.
To install the new lamp 1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector by holding the lamp module by
the handle vertically and guiding it into its slot.
3. Gently press the power end of the lamp module against the projector to ensure
the power plug makes contact with the projector’s power receptacle.
NOTE
You should be able to place the lamp module into the projector easily without
applying much force.
4. Use the Phillips screwdriver to tighten the captive screws.
5. Carefully replace the lamp cover.
6. Connect the power cable.
7. Press the Power button once on the remote control or the ECP to confirm that the
projector is operating and that the lamp module is correctly installed.
To complete the projector
lamp installation
1. Turn on the projector.
2. Adjust the projected image if necessary. See Focusing and adjusting projected
image below.