Sony SLV-E180EG - Manual (Page 10)

Getting Started
9
Getting Started
5
Press PROGRAM +/– (repeatedly) to select the correct TV system.
If you watch the system B/G, select “G”. If you watch the system
D/K, select “K”.
6
Tune the TV to the same channel as that
shown in the display window so that
the picture on the right appears on the
TV screen.
Refer to your TV manual for tuning
instructions.
If the picture does not appear clearly,
see “To obtain a clear picture from the
VCR” below.
7
Press RF CHANNEL.
You have now tuned your TV to the VCR. Whenever you want to
play a tape, set the TV to the video channel.
To check to see if the TV tuning is correct
Set the TV to the video channel and press PROGRAM +/– on the VCR. If
the TV screen changes to a different programme each time you press
PROGRAM +/–, the TV tuning is correct.
To obtain a clear picture from the VCR
If the picture does not appear clearly in step 6 above, go to step 7 to finish
this procedure once. Then start from step 2. After pressing RF CHANNEL
in step 2 to display the RF channel, press PROGRAM +/– so that another RF
channel appears. Then tune the TV to the new RF channel until a clear
picture appears.
RF CHANNEL
AUTO SET UP
PROG
SONY VIDEO CASSETTE
RECORDER
Note
• If you set the wrong TV system, you may have no sound or sound may be distorted.