Sears 831.159370 - Manual (Page 14)

14
30. Route the Long Cable (58) around the 3 1/2” Pulley
(15) on the Butterfly Base (4).
Attach the Long Cable to the Long “U”-Bracket (57)
with a 1/4” Nylon Locknut (2) and a 1/4” Flat Washer
(10).
Do not completely tighten the Nylon Locknut. It
should be threaded onto the end of the Cable
only a couple of turns, as shown in the inset
drawing.
31. Locate the Medium Cable (86). It has a closed loop
on one end and a ball on the other.
Wrap the end of the Medium Cable with the ball
around a 3 1/2” Pulley (15) in the direction shown.
Attach the Pulley to the Butterfly Upright (42) with a
3/8” x 3 3/4” Bolt (71), a 3/8” Flat Washer (9) and a
3/8” Nylon Jam Nut (83).
30
31
29. Move to the other side of the unit. Route the Long
Cable (58) around the second 3 1/2” Pulley (15) on
the Leg Press Arm (89) in the direction shown.
29
15
89
10
57
2
57
15
4
71
15
86
83
9
42
58
58
2
10
32. Wrap the Medium Cable (86) around a 3 1/2” Pulley
(15) in the direction shown.
Attach the 3 1/2” Pulley (15) and a Cable Trap (66) to
the two “I”-plates (81) with a 3/8” x 2“ Bolt (12) and a
3/8” Nylon Locknut (21).
Make sure the Cable Trap (66) is positioned as
shown.
32
66
15
81
86
21
12