Self-diagnosis display, Tuner, Optional components – Sony CMT-L1 User Manual

Page 25: Messages

Advertising
background image

25

GB

Troubleshooting

Tuner

There is severe hum or noise (“TUNED” or
“STEREO” flashes).

• Set the proper band and frequency (see page 16).

• Connect the antenna properly (see page 7).

• Find a place and an orientation that provide good

reception, then set up the antenna again.
If you cannot obtain good reception, we
recommend you connect a commercially
available external antenna.

• The supplied FM wire antenna receives signals

along its entire length, so make sure you extend
it fully.

• Locate the antennas as far away from the speaker

cords as possible.

• Consult your nearest Sony dealer if the supplied

AM antenna wire has come off the plastic stand.

• Try turning off surrounding electrical equipment.

A stereo FM program cannot be received in
stereo.

• Press FM MODE on the remote until “MONO”

disappears from the display.

• See “There is severe hum or noise (“TUNED” or

“STEREO” flashes).”, and check the antenna
condition.

Optional components

There is no sound.

• Refer to General item “There is no sound.” on

page 24 and check the condition of the system.

• Connect the component properly (see page 22)

while checking:

– if the cords are connected properly.

– if the cord plugs are firmly inserted all the way.

• Turn on the connected component.

• Refer to the operating instructions included with

the connected component and start playing.

• Press FUNCTION repeatedly until “MD” (or

“TAPE”) appears in the display.

The sound is distorted.

• Set the volume of the connected component

lower.

If the system still does not operate

properly after performing the above

measures, reset the system as

follows:

With the system turned on, press DISPLAY,
TUNER/BAND and FUNCTION at the same
time.

“COLD RESET” appears in the display and the
system turns off. All system parameters are
reset to their factory settings. Afterwards, be
sure to do the followings procedures again:
presetting the radio stations, setting the clock
and the timer, and labelling the CD.

Note

You cannot reset the system in the Power Saving
Mode.

Self-diagnosis display

Messages

One of the following messages may appear or
flash in the display during operations.

CD

Complete!

CD editing (Disc Memo) finished normally.

File Full

There are already 100 disc titles stored in the
system.

Initialize

The system is being initialized. You cannot load a
CD during this time. Wait until “Initialize”
disappears from the display.

No Disc

There is no disc in the CD player.

—OVER—

You have reached the end of the CD while
pressing and holding down M during playing
pause.

Push STOP!

You pressed PLAY MODE/TUNING MODE
during playback.

Step Full!

You tried to program 26 tracks (steps) or more.

Advertising