Sony CMT-L1 - Manual (Page 9)

9 GB
Getting Started
Preparing the remote
Pull out the insulating sheet to allow
power to flow from the battery.
The remote already contains a battery.
Using the wall hanging
bracket
You can hang the system on the wall using the
supplied wall hanging bracket.
The screws for attaching the wall hanging
bracket to the wall are not supplied. When
installing the bracket by yourself, be sure to use
screws appropriate for the type of wall. Sony
cannot take responsibility for any damages or
injury due to installation.
Safety precautions
• The supplied bracket is for use with the Sony
Interior Hi-Fi Component System CMT-L1 only.
Using this item for purposes other than to hang
the system on the wall may result in accidents.
• The component system CMT-L1 (7.1 kg) and the
wall hanging bracket (0.6 kg) have a combined
weight of 7.7 kg. Therefore, for safety reasons,
the bracket should be attached securely to a wall
made from materials capable of supporting a
load of 50 kg or more.
• When you hang the system on the wall, make
sure the left and right speakers are both attached
or both detached. Attaching one speaker without
the other may cause the system to drop and
injure someone.
Preparation
• The screws for attaching the wall hanging
bracket to the wall are not supplied. Be sure
to purchase screws suited to the wall
materials.
• If the wall materials cannot support a load of
50 kg or more, be sure to reinforce the wall.
Hanging the system on the
wall
1 Fix the wall hanging bracket to the wall
using 8 screws (not supplied).
Note
Be sure to secure the bracket in a level position.
2 Set the speaker cord into the speaker cord
groove at the bottom of the speaker.
Otherwise, the speaker cord could be
damaged.
3 Attach the speakers.
Afterwards, push down on the speakers to
make sure they are securely fastened to the
main unit.
4 Connect the speaker cords to the SPEAKER
jacks.
5 Attach the system to the wall hanging
bracket which you have fixed to the wall.
Make sure to grasp the main unit, and not the
speakers.
After attaching the system to the bracket,
push down on the system to make sure they
are securely fastened to the bracket.