Sharp R-220KW(D) - Manual (Page 19)

17
Disconnect the power cord before cleaning or
leave the door open to inactivate the oven dur-
ing cleaning.
Exterior
The outside surface is painted. Clean the outside with
mild soap and water. Then wipe with a clean damp-
ened cloth and polish dry with a soft cloth. Do not use
any type of household or abrasive cleaner.
Door
Wipe the window on both sides with a soft damp cloth
to remove any spills or spatters. Metal parts will be easier
to maintain if wiped frequently with a soft damp cloth.
Avoid the use of spray and other harsh cleaners as they
may stain, streak or dull the door surface.
Touch Control Panel
Wipe the panel with a soft cloth dampened slightly with
water only. Dry with a soft cloth. Do not scrub or use
any sort of chemical cleaners. Close door and touch
STOP/CLEAR pad.
Interior
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces, wipe
with a soft damp cloth. DO NOT USE ABRASIVE OR
HARSH CLEANERS OR SCOURING PADS. For heavier
soil, use baking soda or a mild soap; wipe clean with a soft
damp cloth. NEVER SPRAY OVEN CLEANERS DI-
RECTLY ONTO ANY PART OF THE OVEN.
Waveguide Cover
The waveguide cover is made from mica so requires
special care. Keep the waveguide cover clean to as-
sure good oven performance. Carefully wipe with a soft
damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly catch fire.
Do not remove the waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the oven.
To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100%
power. Allow to set in oven until cool. Wipe interior with
a soft cloth.
Turntable / Turntable Support
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and a non-abra-
sive scouring sponge. They are also dishwasher-proof.
The turntable motor shaft is not sealed, so excess wa-
ter or spills should be wiped up immediately.
C L E A N I N G A N D C A R E
Exterior
Interior
Turntable
Turntable Support