Sanyo PLC-XM100L - Manual (Page 13)

PLC-XM100/XM100L/XM150/XM150L Basic Serial Command Functional Specifications
13/28
6.10 INPUT 3 Command
Command “C07” [CR]
Detail
Select Input 3. This command works differently from the command by “Input 3”
key of the remote control. When Input 3 has been selected, this command does
not execute the source switching; just for switching to Input 3.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.11 NETWORK Command
Command “C08” [CR]
Detail
Select Network Input.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]