Sanyo PLC-XM100L - Manual (Page 5)

PLC-XM100/XM100L/XM150/XM150L Basic Serial Command Functional Specifications
5/28
1. Overview
・ These specifications define projector control commands for PLC-XM100/XM100L/XM150/XM150L
・ The projector control commands are used to control a projector through RS-232C from a computer.
2. Serial Interface Specification
2.1. Transfer Specification
Item S p e c i f i c a t i o n
Synchronous system Asynchronous
Transmission Speed 9600 / 19200
Data Length 8 bits
Parity None
Stop Bit 1
Flow Control None
① Transmission speed: initial setting value is 19200.
② Transmission speed can be changed in service mode.
2.2. Connection
Dedicated serial cable must be used for the connection between computer and projector.
PC Projector
COM 1 CONTROL PORT
(D-Sub 9Pin) (D-Sub 9Pin)
Connect COM port of the computer to CONTROL PORT of the projector.
COM Port (COM1 or COM2) of a computer is specified by control software of the computer.