Sanyo DSR-3709 - Manual (Page 89)

GENERAL SET 4
88
English
SE
TTIN
GS
z After “VIDEO LOSS” is detected, it can be cancelled by
performing either of the following.
(1) Input a video signal.
(2) If no video input is required, use a [CAMERA SELECT]
button to select the camera for which video loss was
detected and then press and hold the same button.
Use the following procedure to set a warning buzzer to
sound for alarms or when hard disk space becomes
insufficient.
1
Press the [MENU] button, turn the jog
dial to select “3. GENERAL SET”, and
then turn shuttle dial clockwise.
The <GENERAL SET> screen is displayed.
2
Turn the jog dial to select “2. BUZZER
SET”, and then turn the shuttle dial
clockwise.
The <BUZZER SET> screen is displayed.
(1) ALARM (default setting: OFF)
Sounds the buzzer when a alarm occurs.
(2) DISK FULL (default setting: ON)
Sounds the buzzer when overwriting is forbidden and
the hard disk capacity becomes insufficient.
(3) DISK ERROR (default setting: ON)
Sounds a buzzer when a hard-disk error occurs.
(4) LOCK WARNING (default setting: ON)
Sounds a buzzer if a button is pressed while the
security lock is on. Specifically, the buzzer sounds
twice with an interval of approximately 0.5 seconds.
(5) KEY IN (default setting: OFF)
Sounds the buzzer when a button is pressed.
(6) NON REC (default setting: OFF)
A buzzer is sounded upon loss of recording.
3
Turn the shuttle dial clockwise.
“OFF” flashes for “ALARM”.
4
Turn the jog dial to display “ON”, and
then turn the shuttle dial clockwise.
[Settings] (‹ indicates default setting)
Use the above procedure whenever necessary to
change buzzer settings (ON or OFF).
5
Press the [EXIT/OSD] button.
The setting procedure is ended and the display returns to
the normal screen.
z To stop a buzzer, press any button or turn either the jog
dial or shuttle dial.
Setting the buzzer
MENU
<BUZZER SET>
ALARM : OFF
DISK FULL : ON
DISK ERROR : ON
LOCK WARNING : ON
KEY IN : OFF
NON REC : OFF
(1)
(2)
(3)
(4)
(5)
(6)
Setting Description
‹ OFF
The buzzer is not sounded when an alarm is
generated.
ON The buzzer is sounded when an alarm is generated.
<BUZZER SET>
ALARM : ON
DISK FULL : ON
DISK ERROR : ON
LOCK WARNING : ON
KEY IN : OFF
NON REC : OFF
EXIT/OSD
e00_l8hbg_us_7.book Page 88 Thursday, November 25, 2004 1:44 PM